“DQG is my Chinese name Pinyin initials, or call me George” is the opening statement at the DQG website. And the DQG Tiny III 18650 is one of his latest accomplishments!

First Impressions

Being somewhat of a flashlight snob (okay I’ll admit it) when I first heard the name D.Q.G, I thought…”what kind of company is this???” Then I discovered there were earlier products than the Tiny III, and that they actually had a reputation.

The Tiny III w/box & manual

So I received a Tiny III flashlight in the mail and proceeded to look it over. It came housed in a box no bigger than the light itself… 3.5″ long. Included was an instruction manual/product catalog sheet, a pocket clip and a spare o-ring.

The light is fashionably attractive. Yes, people who classify themselves as “flashaholics” actually appreciate the styling of a light to the point where we consider some, ugly, and some, attractive.

The Tiny “III” Is Different

This is actually an upgrade to the original DQG Tiny, which operated by twisting the head for three levels of output.

Your DQG Tiny III Flashlight

Still only using a single 18650 rechargeable battery as its power source, the Tiny III has incorporated a side-switch as its only method of operation. Plus, it added a FOURTH level of output!

There are no springs within the flashlight body or the tail cap. But even so, I’m pleased to note that flat-top batteries appear to work just fine!

The Tiny III uses a CREE XM-L2 LED to produce a nice uniform beam. Its spill versus throw is acceptable. As far as the LED is concerned, the light is produced in both cool white and neutral white versions. THIS is the cool white version.

The Tiny III’s XM-L2 LED

So here’s what you get with the Tiny III.

  • Low at 3.5 lumens for 300 hours
  • Medium at 85 lumens for approx. 80 hours
  • High at 300 lumens for approx. 4 hours
  • Turbo at 800 lumens for *1 minute at a time!

There are NO flashing, signalling, or pulsing modes.

Modus Operandi

So, the little switch near the top of the head does everything.

Give it one press for instant low mode. Or you can double-click the button for medium mode. You can even TRIPLE click it for high mode. All this can be accomplished from the OFF position. Once in ANY mode, a HOLDING press of the button will activate TURBO mode.

The Tiny III side-switch

Alternatively, from low, a double-click will activate medium. Another double-click (from medium) will activate high. One firm press, activates turbo. One quick press from ANY mode, will shut the light off.

One added little feature, is the illuminating o-ring under the lens, which will glow “green” when the light has been turned off.

From the general operation, perhaps you can tell that there is NO memory function on the light. Only because you can select, via button presses, any mode you want from low to high. As the battery voltage begins to drop to just less than half, the Tiny III will “blink” every few seconds…until it finally shuts off.

*A Special Note Regarding Turbo Mode; The Tiny III will only remain in Turbo mode for 60 seconds! It’s automatically timed to bump back DOWN to the previous mode used after one full minute.

A Special Note Regarding Batteries; Although the DQG accepts a 18650 as its main power source, I have not been able to verify if it also accepts other battery sizes. I’ve not seen anything written pertaining to its acceptable voltage range. Most 18650 based flashlights, are able to run on up to 8 volts. This accommodates either two CR123 or two 16340 batteries. I’ve been tempted to try these other batteries in the light, to see if a higher output could be achieved. But just in case it won’t accept anything greater than 4 volts, I don’t feel safe attempting it. If it didn’t… the driver or LED could be irreversibly damaged.

The Beam Shot Photos

As usual, each photo may be clicked on for a FULL size image!

On medium @65 ft

On high @65 ft

On turbo @65 ft

On low @6 ft

On medium @17 ft

On high @17 ft

On turbo @17 ft

On medium mode

On turbo mode

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

The Whole Picture

I like the DQG Tiny III flashlight for just what it is.

It’s compact. It’s lightweight, it’s waterproof to IPX standards. For everyday use it’s mighty bright. Even after turbo mode output bumps down, you can still return to it in an instant. The manufacturer won’t recommended you do that over and over again, but a couple of times in a row is okay.

For those who think most lights of this caliber are too expensive, the DQG’s price point is lower than most. At last check, this particular model was discontinued… BUT, you can pick up something similar by clicking here!.

 

Have a question or comment about this review? Please let me know below!

BR Wilkie

Recent Posts

Jetbeam E26 Kunai UV Flashlight Review

I haven't owned a new Jetbeam flashlight is quite some time. Having said that, I'm…

3 months ago

Nitecore HC65 Headlamp Review

Since the motto of Nitecore is "keep innovating" please join me now in this review…

8 months ago

Nitecore EDC33 Lumin Shield Flashlight Review

As Nitecore continues to implement new concepts with LED flashlights, let's dive in with my…

11 months ago

Wuben X3 Wireless Charging LED Flashlight Review

This is different! The Wuben X3 "Owl" is a dual-LED flashlight that features wireless charging…

1 year ago

Imalent MS03 High Lumen Flashlight Review

I've had a few flashlights from Imalent over the years, and today I'm reviewing one…

1 year ago

Acebeam E75 USB Rechargeable Flashlight Review

Today I'm reviewing the Acebeam E75. Stick around for this one....because I think you'll like…

1 year ago

This website uses cookies.